RE: alter table xxx alter column yyy set (n_distinct=nnnn );

Thanks very much for the reply.
I tried setting

alter table ctrg.xxx alter column p_id set (n_distinct_inherited=-0.033 );
alter table ctrg.xxx alter column pi_id set (n_distinct_inherited=-0.045 );
alter table ctrg.xxx alter column i_id set (n_distinct_inherited=-0.0002 );

I then ran
analyze xxx;
but saw no change in pg_stats.n_distinct for xxx.
Reviewing the values for pg_stats.n_distinct in the partitions of xxx,
- values for i_id are all positive
- values for p_id are a mix - mostly positive, a few negative, but none carry the value I attempted to set
- values for pi_id are all negative, but none carry the value I attempted to set

Thanks,
Mike Tefft

-----Original Message-----
From: Laurenz Albe <laurenz(dot)albe(at)cybertec(dot)at>
Sent: Monday, March 11, 2024 9:21 AM
To: Tefft, Michael J <Michael(dot)J(dot)Tefft(at)snapon(dot)com>; pgsql-general(at)lists(dot)postgresql(dot)org
Subject: Re: alter table xxx alter column yyy set (n_distinct=nnnn );

On Mon, 2024-03-11 at 12:36 +0000, Tefft, Michael J wrote:
> I have been struggling to set n_distinct on a few table columns, and confirm that my changes have actually been accepted.
>  
> I have a 400-million row table with 81 partitions. PostgreSQL version is 14.11.
> Column p_id has 13 million distinct values but pg_stats says n_distinct is only 82k.
> Column pi_id has 18 million distinct values but pg_stats says n_distinct is only 29k.
> Column i_id has 70k distinct values but pg_stats says n_distinct is only 1800.
>  
> I tried:
> alter table xxx alter column p_id set (n_distinct=-0.033 ); alter
> table xxx alter column pi_id set (n_distinct=-0.045 ); alter table xxx
> alter column i_id set (n_distinct=-0.0002 );
>  
> All ran without error, but pg_stats shows no changes. I tried:
>  
> alter table xxx alter column p_id set (n_distinct=13118955 ); alter
> table xxx alter column pi_id set (n_distinct=18059179 ); alter table
> xxx alter column i_id set (n_distinct=69911 );
>  
> Again, all ran without error, but pg_stats shows no changes.
>  
> I saw somewhere (but can’t locate the reference today) that setting n_distinct takes effect after the next ANALYZE. I tried ANALYZE xxx and VACUUM ANALYZE xxx but the settings never appeared to take effect.
>  
> I tried increasing “statistics” on the columns to 1000 and running ANALYZE; this produced somewhat-higher n_distinct values but still far from accurate and my manually-set values still did not appear.
>  
> How can I get these values to take effect?

If it is a partitioned table, set "n_distinct_inherited" on the column, then run ANALYZE.

Yours,
Laurenz Albe