| From: | Andrew Dunstan <andrew(at)dunslane(dot)net> |
|---|---|
| To: | Tom Lane <tgl(at)sss(dot)pgh(dot)pa(dot)us>, Erik Rijkers <er(at)xs4all(dot)nl> |
| Cc: | Peter Eisentraut <peter_e(at)gmx(dot)net>, pgsql-hackers(at)postgreSQL(dot)org |
| Subject: | Re: Re: [COMMITTERS] pgsql: Build HTML documentation using XSLT stylesheets by default |
| Date: | 2016-11-16 15:16:31 |
| Message-ID: | 3246f247-c850-75cb-64ca-d57fdbd119f1@dunslane.net |
| Views: | Raw Message | Whole Thread | Download mbox | Resend email |
| Thread: | |
| Lists: | pgsql-committers pgsql-hackers |
On 11/16/2016 09:46 AM, Tom Lane wrote:
> Erik Rijkers <er(at)xs4all(dot)nl> writes:
>> This xslt build takes 8+ minutes, compared to barely 1 minute for
>> 'oldhtml'.
> I'm just discovering the same.
>
>> I'd say that is a strong disadvantage.
> I'd say that is flat out unacceptable. I won't ever use this toolchain
> if it's that much slower than the old way. What was the improvement
> we were hoping for, again?
>
>
On the buildfarm crake has gone from about 2 minutes to about 3.5
minutes to run "make doc". That's not good but it's not an eight-fold
increase either.
cheers
andrew
| From | Date | Subject | |
|---|---|---|---|
| Next Message | Robert Haas | 2016-11-16 15:25:12 | Re: Re: [COMMITTERS] pgsql: Build HTML documentation using XSLT stylesheets by default |
| Previous Message | Tom Lane | 2016-11-16 14:46:16 | Re: Re: [COMMITTERS] pgsql: Build HTML documentation using XSLT stylesheets by default |
| From | Date | Subject | |
|---|---|---|---|
| Next Message | Robert Haas | 2016-11-16 15:25:12 | Re: Re: [COMMITTERS] pgsql: Build HTML documentation using XSLT stylesheets by default |
| Previous Message | Robert Haas | 2016-11-16 15:13:14 | Re: [HACKERS] Patch: Implement failover on libpq connect level. |