Correction for the Binary Replication Tutorial

To it my concern,

I was following your 5 minutes to Simple Replication tutorial found here
http://wiki.postgresql.org/wiki/Binary_Replication_Tutorial#5_Minutes_to_S
imple_Replication, and I notice a mistake.

In step 3 you state that the recovery.conf should be placed in the same
directory that the postgres.conf file is located. While the official
documentation states to put the recovery.conf in your ${PG_DATA}
directory, which in the case of your tutorial is /var/lib/postgresql/data,
where as the postgres.conf file lives at /etc/postgres/path/postgres.conf
. I understand if your setup is different than mine, but you might want to
make a note of this on the tutorial.

I tried it the way that you have it in your tutorial and it did not work,
the wal receiver process would not start.

Thanks
-------------------------------------
Michael Smith, Software Test Engineer

PC-Doctor, Inc.
9805 Double R Boulevard, Suite 301
Reno, NV 89521
775-336-4097
michael(dot)smith(at)pc-doctor(dot)com

CONFIDENTIALITY
The information contained in this message is confidential. It is intended
to be read only by the individual or entity to whom it is addressed or by
an authorized designee. If the reader of this message is not the intended
recipient, be aware that distribution of this message in any form is
strictly prohibited. If you have received this message in error, please
immediately notify the sender and destroy any copy of this message.