Re: Setting up streaming replication with new server as master?

* Dave Johansen (davejohansen(at)gmail(dot)com) wrote:
> On Fri, Feb 5, 2016 at 1:54 PM, Stephen Frost <sfrost(at)snowman(dot)net> wrote:
> > * Dave Johansen (davejohansen(at)gmail(dot)com) wrote:
> > > So will pg_basebackup keep copying the new data that is added over the
> > > weekend until I tell it to stop? If so, then on Monday, can I close
> > things
> > > down, wait for the WAL to finish, swap the roles of the 2 server and then
> > > restart?
> >
> > No, pg_basebackup will take a snapshot of the current system,
> > essentially. You can set up the new system to connect to the current
> > system, using recovery.conf, to pull the WAL records and apply them to
> > the new server.
> >
>
> So do I set that up before running pg_basebackup?
>
> Or in other words, pg_basebackup will get all of the existing data and then
> the setup using recovery.conf will get the new data?

Right. Note that to use pg_basebackup or to have a replica connect to
the existing system, you need to have archive_mode set to archive or
higher (and you should at least do hot_standby, really), and have
max_wal_senders set higher than 0 (I tend to set it to about 3, just
because it uses little in the way of resources, etc). If you have a
high transaction rate, you might also want to set wal_keep_segments up a
bit.

Thanks!

Stephen